Tips for maintaining the temperature of the sludge dryer cylinder

The temperature determines the drying speed of the dryer and the output of the dried material. The sludge dryer dries the material by absorbing a certain amount of heat, and needs to maintain the temperature in the cylinder for a long time. This is a prerequisite for drying the material. Due to various reasons, the sludge dryer will lose part of the heat, and the drying effect will be greatly reduced. Here are some tips for maintaining the temperature in the drum dryer.

When designing the sludge dryer, there will be some small deviations, resulting in the mismatch of equipment production capacity, causing excessive fuel consumption, and affecting the drying output. Therefore, we can add a layer of insulation material in the sludge dryer, which can improve the heat storage capacity of the sludge dryer and reduce the combustion speed of the heat energy of the sludge dryer.

If the heat source of the sludge dryer is consumed too quickly, the insulation of the combustion device will be poor, resulting in a large area of ​​heat energy loss after the fuel is burned. In this way, the sludge dryer will not be able to maintain the effect of high temperature on the material. At this time, we need to appropriately reduce the heat energy to avoid the material from being unable to exchange with heat.

Sludge dryers are equipped with special temperature detectors. At this time, the operator needs to detect the temperature detector to prevent the phenomenon of too low temperature in the early stage and too high temperature in the later stage. If the temperature is too low, the drying effect will be poor, and if the temperature is too high, the material will be over-dried. Therefore, the operator should pay attention to monitoring the temperature detector.

The interior of the sludge dryer has a furnace specially used to prevent the temperature from being too high. The operator must plan to ensure the stability of the temperature and ensure that the dryer can effectively dry the material to avoid incomplete drying. At the same time, the fuel data calculation should be detected and the air volume and wind speed should be adjusted.

We can use the above method to control the temperature of the sludge dryer cylinder to keep it at a specific temperature. At the same time, we must also consider economic issues, minimize investment, and strive for value.