How to deal with the heating problem of slag dryer bearings

Reasons for heating of slag dryer bearings:1. Lack of lubricant during the use of the slag dryer will cause severe friction between the bearings during operatio

How to optimize the discharge system of the three-drum dryer?

The three-drum dryer is a drying equipment consisting of three cylinders nested together and arranged coaxially. Through the different hot air effects of the in

How to adjust the sand dryer to adapt to sand with different humidity

The sand dryer can effectively dry wet sand through the optimized hot air system and drying cylinder design. It can handle various types of sand and is suitable

Operations that should be paid attention to during the running-in period of river sand dryer

There will be a period of adaptation period (running-in period, usually 3 days) before the river sand dryer enters normal work. This period is to ensure that th

Common faults and troubleshooting methods of slag dryers

As the slag drying operation time increases, it is inevitable that the slag dryer will have faults of varying sizes. Once a slag dryer fails, it will affect the

The combination form of water in the material during the kaolin drying process

1. Free water: It is the water absorbed when the material is in direct contact with water. It exists in the large capillary with a diameter of 10-5 cm. The wate

Sand dryer height-to-diameter ratio and aperture processing issues

The height-to-diameter ratio of the sand dryer depends on the time the material needs to stay in the kiln for preheating, decomposition, sintering and cooling.

Introduction to rust prevention techniques for sludge dryers

Rust prevention is very important for sludge dryers. Sludge dryers are subjected to wind and humidity for a long time, and the erosion of high temperature in su